Or at least part of it, as it's still under construction.
This is my attempt to build the Capital Division logo from Perler beads. Shortly after getting a 11,000 bead pack (for $10), I started planning this in Perler and building this after acquiring some pegboards.
I did run into a problem though. Either I need a lot more beads than this (maybe a few thousand, which would cost me around $20) or I need to size it down from a 150x150 grid. I've heard suggestions saying to shrink it down to a more manageable size, but I would be losing too many details. What will it be?
I've also been asked where I would place this when it's done... let's worry about this later.
UPDATE: This perler bead project was finished on June 18 and can be found here.
Interest History: I first heard about these beads through Sac State Circle K (more specifically from Alex Ung as he was showcasing models that were completed and used for fundraising). I found potential interest in them after looking at bead sprites and the possibility of creating the Capital Division logo from them, although he claimed that it would be hard to build one as there were too many details that couldn't be included in a small model.
0 comments:
Post a Comment